Drayton digistat scr receiver manual

Digistat RF units are matched correctly to the relevant SCR. This is easily achieved by commissioning each Digistat and SCR in turn. 1. Install (see installation instructions) and turn power on to the SCR (receiver). If a separate programmer is fitted, ensure that it is switched on. The red LED should come on. 2.  · Drayton digistat scr instructions manual. Drayton Digistat+1 manual 1. Install (see installation instructions) and turn power on to the SCR (receiver). If a separate programmer is fitted, 2. Push the ‘override ’ button on the SCR once. The green LED should also come on. Check to see if the boiler and/or 3. 1. Do not install the Digistat +RF transmitter until after you have completed the commissioning process. 2. Pull down the battery drawer in the Digistat unit and the screen will go blank. 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds. 4. Turn the power back on to the SCR unit and check red light is on. 5.

View the manual for the Drayton Digistat+1 here, for free. This manual comes under the category Thermostat and has been rated by 1 people with an average of a This manual is available in the following languages: English. Do you have a question about the Drayton Digistat+1 or do you need help? Ask your question here. 2. Pull down the battery drawer in the Digistat unit and the screen will go blank. 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds. 4. Turn the power back on to the SCR unit and check red light is on. 5. with the operation and use of the Drayton Digistat RF range of products. Put the SCR unit into its manual. Digistat+C RF Boost 1 Hr BOILER 30cm Min Preferred side of boiler The range may be affected by composition/density and number of walls between the Digistat +CRF and SCR V a.c. V a.c. Digistat+C RF Heating Radio Signal Range: 30m Typically SCR Technical Helpline: +44 (0) www.doorway.ru Email: www.doorway.ru

User manual for the Drayton Digistat +RF2 in English. Mains - Digistat SCR User Instructions Event 1 2 3 4 5 6 Time Drayton scr receiver /Lflo/ British Gas Digistat RF/// however if you are asking for instructions for the drayton scr receiver you can find. The Digistat SCR (receiver) should be mounted in a convenient position, close to the combi boiler or central heating system wiring centre. (Care should be taken.